Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Santa Ana, CA
Chimney repair in Santa Ana usually means dealing with a 70 to 100 year old masonry structure that has spent decades in a dry climate with sporadic use. The work here rarely involves freeze-thaw cracking. Instead, we see terra-cotta liners that have spalled from age, crowns worn down by years of wind-driven grit, and flashing that leaks during the occasional heavy rain. Walnut Chimney has served Santa Ana since 2017, and our repair work starts with the same question every time: what does the inside of this flue actually look like? Call (855) 341-3461 and we will show you, on camera, before anyone quotes a dollar figure.
Why Santa Ana Homes Are Different
Santa Ana’s chimney stock splits into two categories. In the central and eastern ZIPs (92701, 92703, and the older sections of 92706), most homes were built between 1920 and 1955. These are brick and stucco masonry chimneys, often with original terra-cotta liners that have been in place for nearly a century. In French Park and Lacy, many of those chimneys have been sealed or capped for years. When a new owner opens one up, the liner is frequently cracked or flaking, and the crown has eroded from decades of dry winds. The second category is simpler: newer tract homes in south and north Santa Ana (92704, 92707) usually have prefabricated metal fireplaces. Those need different tools, different replacement parts, and a lighter hand than a 1920s brick flue. The climate shapes the work too. Dry Santa Ana winds push debris, soot, and nesting material back down uncapped flues. And because most homeowners burn wood only on cool winter evenings, fires tend to smolder. That produces a thin, glazed creosote that is harder to remove than the fluffy stuff you get from hot, frequent burns.
Styles & brands we work with
Our Main Santa Ana Services
Most Santa Ana calls start with one of two problems: a fireplace that has not been cleaned in years, or a dryer vent that has never been cleaned at all. Both are fire risks, and both are jobs we handle in a single visit.
Chimney Sweep in Santa Ana
A sweep in Santa Ana is not a generic brush-through. The older masonry chimneys in French Park, Lacy, and the surrounding historic districts often have glazed creosote from smoldering fires, and that requires rotary cleaning tools, not just a wire brush. We also check the cap, crown, and damper during every sweep, because in a dry climate the things that go wrong are often visible from the top down. For a full breakdown of what a sweep includes and what it costs here, see our Chimney Sweep in Santa Ana page.
Dryer Vent Cleaning in Santa Ana
The same dry air that keeps Santa Ana chimneys relatively creosote-light is exactly what makes dryer vents dangerous. Lint in a dry vent is fuel. If the vent run is long, runs through a slab, or terminates on a roof, the buildup happens faster and the stakes are higher. We treat dryer vent cleaning as a primary fire-safety service, and we handle it with the same inspection standards as a chimney job. Details are on our Dryer Vent Cleaning in Santa Ana page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Santa Ana
Chimney repair in Santa Ana is usually a masonry preservation job. The homes here are old enough that the original terra-cotta liners are spalling, the crowns are cracked or gone, and the flashing at the roof line has pulled away after decades of sun and wind. The good news is that Santa Ana’s mild winters mean repairs can be scheduled year-round. The bad news is that none of these problems fix themselves, and a damaged flue liner or missing cap is a direct fire and carbon monoxide risk. Our Chimney Repair work always includes a camera inspection, and we show you the footage before recommending a single repair. We work with professional-grade materials including Olympia Chimney caps, Famco venting components, Copperfield flashing products, and DuraFlex liner systems, so the repair matches the house.
Chimney Cap Installation
Signs you need it
You can see daylight through the top of your flue, or you have had birds, bees, or rodents in the chimney.
What it costs in Santa Ana
Chimney cap installation in Santa Ana typically runs $150 to $400 depending on flue size and whether the crown needs a mounting surface first.
How we do it
We measure the flue, prep the crown if needed, and install an Olympia Chimney or Famco cap with a sealed base so it stays put in the wind.
Chimney Cap Replacement
Signs you need it
The existing cap is rusted through, lifted off, or missing entirely after a windstorm.
What it costs in Santa Ana
Replacing an existing cap in Santa Ana generally falls between $120 and $350 including the new cap and removal of the old one.
How we do it
We remove the damaged cap, check the flue opening for damage or nesting, and fit a correctly sized replacement from Olympia Chimney or Famco.
Chimney Liner Installation
Signs you need it
Your camera inspection shows cracked, spalled, or missing terra-cotta tiles, or the flue fails a level 2 inspection.
What it costs in Santa Ana
A new chimney liner in Santa Ana typically runs $1,500 to $5,500 depending on length, diameter, and whether the old liner must be broken out first.
How we do it
We run a camera first, then install a DuraFlex stainless steel liner or perform a ceramic resurfacing, and finish with a full draft and leak test.
Chimney Flashing Repair
Signs you need it
You see water stains on the ceiling near the chimney, or the flashing is pulling away from the brick.
What it costs in Santa Ana
Chimney flashing repair in Santa Ana usually falls between $300 and $800 depending on how much of the roofline must be opened up.
How we do it
We remove the failed flashing, install new Copperfield flashing or a compatible metal, and seal it with a high-temperature, weather-resistant sealant.
Chimney Crown Repair
Signs you need it
The concrete or mortar top of the chimney is cracked, sloped toward the flue, or has pieces missing.
What it costs in Santa Ana
Crown repair in Santa Ana typically runs $400 to $1,200 depending on whether it is a recoat or a full rebuild.
How we do it
We clean the crown, fill cracks or rebuild the surface, and slope it away from the flue so water sheds properly.
What Chimney Repair Costs in Santa Ana
Here is what Santa Ana homeowners can expect, based on the work we do most often in the area.
| Item | Typical range in Santa Ana |
|---|---|
| Chimney cap installation | $150 – $400 |
| Chimney cap replacement | $120 – $350 |
| Chimney liner installation | $1,500 – $5,500 |
| Chimney flashing repair | $300 – $800 |
| Chimney crown repair | $400 – $1,200 |
Does chimney repair in Santa Ana cost more because the homes are older?
Not necessarily. Age matters less than condition. A 1920s chimney with a solid liner and crown may need only a cap, while a 1990s prefab with a damaged chase top can be expensive to correct. The camera inspection is what determines the real number, and we show you the footage before quoting anything.
Can you repair a chimney in Santa Ana without relining the whole thing?
Often, yes. If the liner shows minor cracking but the structure is sound, HeatShield ceramic resurfacing can restore the flue surface without a full liner replacement. We only recommend relining when the camera shows damage that resurfacing cannot safely address. Call (855) 341-3461 and we will walk you through what your flue actually needs.
Brands We Service in Santa Ana
Walnut Chimney installs and services parts from Olympia Chimney, Famco, Copperfield, and DuraFlex. We keep common cap sizes, flashing materials, and connector parts in stock for Santa Ana jobs, so repairs do not wait on a warehouse shipment. For more on the equipment we use, see our brands.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Santa Ana, CA
| Service | Typical range in Santa Ana |
|---|---|
| Chimney sweep (standard, one flue) | $180 – $340 |
| Chimney sweep with glazed creosote removal | $350 – $600 |
| Dryer vent cleaning | $120 – $250 |
| Chimney cap installation | $150 – $400 |
| Chimney cap replacement | $120 – $350 |
| Chimney liner installation | $1,500 – $5,500 |
| Chimney flashing repair | $300 – $800 |
| Chimney crown repair | $400 – $1,200 |
The two things that push a price up in Santa Ana are glazed creosote (which takes longer to remove than fluffy soot) and masonry deterioration on pre-1950 chimneys (which often needs crown or flashing work before a sweep makes sense). Every job gets an upfront price before we start, and no repair is ever recommended without camera evidence you can see for yourself.
Neighborhoods We Serve in Santa Ana
We work across Santa Ana, from the historic streets of French Park and Lacy to the newer tracts in the south and north. Response time for most Santa Ana appointments is within a few days, and we group calls by ZIP so a visit to 92701 or 92703 does not leave you waiting two weeks.
- French Park
- Lacy
- Floral Park
- Mabury Park
- Delhi
Service Area – Cities Near Santa Ana
Walnut Chimney also serves homeowners in Tustin, CA, North Tustin, CA, Fountain Valley, CA, and Orange, CA. If you are in a neighboring city and need a sweep, repair, or dryer vent cleaning, the same crew and the same camera-first standard apply.
Serving Santa Ana, CA — Our Local Coverage Area
We’re based in the Santa Ana area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Santa Ana
Most Santa Ana appointments are scheduled within a few business days. We are not a franchise call center, and our routing groups Santa Ana ZIP codes together so the technician who arrives already knows what kind of housing stock to expect in 92701 versus 92704.
Most repairs, sweeps, and cap installations do not require a city permit. Liner installations and structural rebuilds sometimes do, depending on scope. We will tell you plainly if your job needs a permit, and we handle the paperwork on our end when it does.
Yes. That is the point of Walnut Chimney. We sweep, inspect with a camera, and if the repair is straightforward, we can often handle it the same day. Larger liner or crown work gets scheduled as a follow-up with a firm date and an upfront price before we leave. Call (855) 341-3461 to set one up.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Santa Ana Customers Say
"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
— Megan Ackerman"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Beatriz Vargas"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
— Luis Garcia